Your wheel stud and lug nut are the only thing holding your wheel on at 100+ MPH!!  

Made in USA for race applications.

These 14mm x 1.25 thread wheels studs are custom made for MINI race applications.  They are 92mm total length with 16mm of bullet nose, 51mm of lug nut thread, 10mm of shank and 15mm to thread into the wheel hub.   Heat treated with rolled threads and rated at 190,000psi.  These wheel studs work with hub centric spacers up to 20mm.  Lug nuts use standard 19mm socket.  Designed for easy uses in both stock and aftermarket wheels with 60 degree taper. Coated yellow, to prevent rusting and for easy locating on the ground or in your tool box. 

Includes 20 lug nuts and studs. 

Spec Sheet for stud:

Wheel stud total length- 92mm

Lug nut threaded length- 51mm

Bullet nose length- 16mm

Shank length- 10mm

Thread wheel hub end length- 15mm

Spec Sheet for nut:

17mm standard socket for 12mm and 19mm standard socket for 14mm

Fit most aftermarket and stock wheels

Insights:

Wheel studs make mounting wheels easier and are recommended for all aftermarket wheels.  Use small amount of antiseize on lug nut threads during install and use Red Loctite to install the stud in the hub.  Recheck wheel studs after first use and spot check from then on.  Replace wheel studs every 2 years.