Sneed4Speed Carbon Rear Wing Install
Lay wing on table and install brackets to bottom of the wing
Attach main support to wing mount
Attach adjustable stanchion to rear most wing mount hole
Attach truck mount plates to main support and adjustable stanchion
Place wing on to trunk at center and rear edge. Mark location and lift trunk, note under structure on trunk lid
Drill holes though trunk lid and under structure
Remove small amount of under structure until washers rest flat on underside of trunk lid
Remove trunk mounts from wing and bolt to trunk
Install wing on to trunk and tighten bolts
Adjust wing to 5 degree down in front
Test drive
For more down force add more angle